A Session within the IBMS Point Configuration Wizard

This chapter describes the process of creating and navigating a Session within the IBMS Point Configuration Wizard. A Session represents a single cycle within the configuration process, which includes both equipment configuration and subsequent point configuration within the configured equipment.

The six steps in a Session are as follows;

1. Location: To set up the location of the equipment

2. Asset: To set up the relevant asset

3. Equipment Template: To configure the relevant equipment template for equipment

4. Zone: To select the relevant zone

5. Equipment: To configure equipment

6. Point Configuration- To configure points in respective equipment

During a Session, the initial steps focus on equipment configuration, with the final step dedicated to point configuration.

Start a Session in IBMS Point Configuration Wizard

To start a Session in the IBMS PC Wizard;

1. Log into your dashboard and scroll down to access the IBMS Point Configuration Wizard. If there are any previously configured sessions, they will be readily visible on the homepage.

   

   Figure 2: Homepage- IBMS Point Configuration Wizard with previously configured sessions
2. Click the New Session button to initiate the creation of a new Session. A pop-up window appears.

3. In the pop-up window, enter an identification name for your Session in the Session ID field.

4. Provide a brief description of the Session.

5. Click Create to proceed.

   

   Figure 3: Creating a Session in IBMS PC Wizard